GodHand GH-DBQ-5C Quick drill bit set of 5 (C)

A specially designed hexagonal shaft drill bit specially designed for model making!
You can dig holes safely without worrying about it spinning freely.

A set of 8 pieces with a 4mm hexagonal shaft and drill diameters of 1.1mm, 1.2mm, 1.3mm, 1.4mm, 1.6mm, 1.7mm, 1.8mm, and 1.9mm .

-The hexagonal shaft fits securely into the connection, so there is no need to worry about it spinning freely, allowing you to work with peace of mind.

- Compared to general drill bits, the overall length is shorter and the distance to the target is closer, making it easier to aim and control.

- The tip of the drill bit is designed with a blunt angle, so it can dig shallowly and make holes without penetrating thin plastic boards. It
　digs more slowly than a sharp-edged cutting edge, so it is less likely to shake and the hole is less likely to become distorted. The edges of the dug hole are also finished neatly.

・In addition, cutting edges are added to the tip of drill bits over 1.5mm!
　The increased biting power allows you to dig with less force and without resistance.
　*There are four drill bits with cutting edge design: 1.6mm, 1.7mm, 1.8mm, and 1.9mm.

What's more, if you use
the separately sold magnetic " Quick Power Pin Vise
", you can easily attach it by simply inserting it! It's very easy to attach and detach the pin vise, which increases your work efficiency!

Maintenance is also important! Maintain it properly to use it for a long time!
・Remove any cutting debris after use.
・After use, wipe off any fingerprints and apply anti-rust oil.
・Because sebum can cause rust, be sure to wipe it off with a clean cloth.
・After use, be sure to store it in its case.
・Do not store in a humid place.