GodHand GH-SWN-125 Metal Line Nippers

The industry's first
metal line compatible nippers for flat cutting metal wires from 0.042mm to 2mm

■Double-edged nippers for metal wires, focusing on metal wires used in model making to Φ2mm brass wires.
Cuts with a "flat cross section" instead of the "crushed cross section" common with general metal wire nippers!
This one tool can be used for a wide range of metal wires used in models.

■ Beautiful cross section/shortened finishing time It cuts as flat as possible without crushing, so there is almost no change in the shaft diameter due to
crushing and swelling. It can also be used to cut metal wires of various sizes, from 0.02 (0.042) metal lines to Φ2mm brass wires !

• Uses God Hand's unique blade-cutting technology, "Hybrid Edge." Looking from the center of the blade, the blade is cut differently on the tip half and the base half, so this single tool can handle wires from ultra-thin to 2mm. Specialized for cutting wires with a tip of 0.5mm or less and a base of 0.5mm to 2mm
• The blade is sharpened to produce the flattest possible cut surface for the wire.
• Cutting is possible with less force than with pliers of the same size (our comparison)
• Each item is handmade by a veteran blade sharpener.

*According to our research as of April 2020

●Quality description
・Double-edged pliers for metal wires ・With spring ・Total length: Approximately 130 mm ・Weight: Approximately 65 g ・Soft grip
・Blade hardness: HRC56 or higher ・With cap

●Cutting capacity
・Brass wire: Φ0.2 mm (tip) to 2 mm (base)
・Metal line: No. 0.02 0.042 mm and up (tip)
・Copper wire: Φ0.2 mm (tip) to 2 mm (base)
・Aluminum wire: Φ0.2 mm (tip) to 2 mm (base)
・Stainless steel wire (not hardened): Φ0.5 mm or less (base)
*Never cut stainless steel wire with the tip of the blade
*Cannot cut hardened wires, high hardness types, stainless steel etching parts, spring materials, etc.
*Piano wire is not suitable for cutting

⚠Precautions
・Do not cut wires other than the intended wire
・For safety, wear protective glasses
・There is a risk of the object flying off, so make sure there are no people or fragile objects around before working
・Do not touch the blade directly
・Do not apply a load greater than the capacity of the blade. Be especially careful with the load on the tip
. To prevent rust, wipe off any dirt or fingerprints and apply oil to the shaft and cutting edge
. Store in a case out of reach of small children.

mm) metal lines to Φ2mm brass wires !